For setup, proceed as follows.
Fig. 26: Setup, step 1
Fig. 27: Setup, step 2
Issue 4/2019 ver. 2.0 page 39 of 42
Köster & Co. GmbH • D-58256 Ennepetal • Spreeler Weg 32 • Tel. +49 2333 8306-0 • Fax +49 2333 8306-38
Internet: http://www.koeco.net • E-Mail: koeco@koeco.net
Remove the 3 support legs, the lock
ring and the protective bellows. Keep
these for later re-use.
2. Screw the rounded lock ring (Pos. 6)
onto the piston manually.
4. Tighten the lock ring (combination tool).
3. Insert the cylindrical pin (Pos.7) into
the piston to the stop.
1. Thread a P5x sealing disc (Pos. 5) over the
piston and press it about 2 mm down into
the base ring, using a socket spanner
(combination tool).
To Next Page
Loading...