Back
Next
Index
Cleaning the IR or Anti-aliasing Filter
1 Remove the filter from the DCS 645 (page 43).
2 Gently blow off the dust using commercially
available canned air (low pressure). If the filter
is still dirty, contact your dealer or service
representative.
3 If the imager is dirty follow the instructions
below:
✔ O n a c o m p u t e r w i t h I n t e r n e t a c c e s s , g o t o
www.kodak.com, then click on the Service
and Support link.
✔ On the Search Service and Support page
type “cleaning an imager” then, follow the
instructions under “Cleaning
Recommendations for CCD Coverglass”.
Storing
These storage tips apply to the DCS 645. Store
the camera body as described in its User’s
Manual.
If you have an IR or anti-aliasing filter not in use,
store it in the pocket on the included body cap.
Before You Begin
To Next Page
Loading...
