4-5
Installation
4
You are now ready to run the newly installed software. See the following chapters
for detailed instructions on the software.
When using DC120 software, if your computer does not recognize that the
camera is attached and turned on, you may need to adjust the serial port and
speed settings. Use the software’s Preferences or Properties window to adjust the
camera communications settings.
9 Verify the name of the
Program Folder and click the
Next button.
☞ If necessary, type a new
folder name or select
from the Existing
Folders list.
A progress screen appears
while the software is
installed. It takes
approximately two minutes to
install all the software on
most systems.
10Select the restart option and
click the Finish button.
☞ If you have installed
the Kodak DC120
Mounter software you
must restart your
computer.
To Next Page
Loading...
Need help?
General
