Kodak i1220 Plus - Maintenance; Opening Scanner Cover

A-61560 January 2010 4-1
4 Maintenance
Contents Opening the scanner cover............................................................. 4-1
Cleaning procedures.......................................................................4-2
Cleaning the rollers ...................................................................4-2
Cleaning the separation module.................................................4-3
Cleaning the feed module ..........................................................4-4
Vacuuming the scanner..............................................................4-6
Cleaning the imaging area ......................................................... 4-6
Running a transport cleaning sheet............................................4-7
Replacement procedures ...............................................................4-8
Replacing the separation module and tires................................4-8
Replacing the pre-separation pad ............................................4-10
Replacing the feed module and tires ........................................ 4-11
Adjusting the pre-separation roller tension ...................................4-13
Supplies and consumables ..........................................................4-14
Opening the scanner
cover
1. Before opening the scanner cover, be sure the input tray is in the
open position and, if the optional output tray and/or dangler are
attached, remove them.
2. Press and hold the scanner cover release lever and pull the scanner
cover down.
3. When you finish cleaning the scanner or replacing a part, close the
scanner cover with both hands.