111
Connecting to your Printer
1. Make sure the printer is turned on.
2. Connect one end of the supplied Micro
USB cable to the Micro USB port on your
camera.
3. Connect the other end of the cable to the
USB port on the printer.
If the camera is not connected to a PictBridge
compatible printer, the following error message
will appear on the LCD.
The error message above will also appear
if the USB mode is set incorrectly, in
which case you should disconnect the
Micro USB cable, check the USB mode
settings, ensure that the printer is turned
on, and then try connecting the USB
cable again.
To Next Page
Loading...
