Kodak PIXPRO WPZ2

39
1. Rotate the mode dial to and then enter the
Wi-Fi selection interface.
2. Press the left/right arrow buttons to select and
set options.
Settings Station AP mode
Wi-Fi Mode
In AP mode, the camera will act
as an access point enabling another
Wi-Fi device to connect to it.
 [Settings] ：
Customize the Wi-Fi settings for the camera
system.
 [Station] ：
Use the Station Mode to connect to a
“Personal Hotspot” created by your mobile
device.
 [AP Mode] ：
In AP mode, the camera will act as an
access point enabling another Wi-Fi device
to connect to it.
Press the mode button to disconnect.
AP Mode
This camera may connect with your smart device
through Wi-Fi.
Settings of Camera:
1. Select and press the button to enter the
setting interface.
2. Press the up/down buttons to select options to
be adjusted, and press the button to enter
the option setting interface.
AP mode
Back
Refresh
Setting pre-connected device for the
following serial number:
SSID:
PIXPRO WPZ2_XXXX
WPA2-PSK: XXXXXXXX

