8-4 Disassembly/Reassembly TP-5648 8/93
rotating diode circuit board from the rotor
assembly.
14. Remove the screw and flat washer securing the
exciter armature using a 9/16-inch wrench.
Remove the exciter armature from the rotor
assembly. See Figure 8-10.
1
2
1. Screw
2. Exciter Armature
Figure 8-10. Removing the Exciter Armature
15. Remove the bolts from the two generator
vibromounts using a 1/2-inch wrench. See
Figure 8-11.
Figure 8-11. Removing the Vibromount Bolts
16. Using a hoist, raise the alternator end of the
generator. See Figure 8-12.
NOTE
Usea hoist with a lifting capacity of one-half ton or
greater.
17. Place a wood block under the flywheel housing
and lower generator until block supports
alternator. See Figure 8-12.
Figure 8-12. Using Hoist to Raise Generator Set
18. Remove the four overbolts securing the end
bracket using a 17-mm socket and ratchet. See
Figure 8-13.
Figure 8-13. Removing the Overbolts
To Next Page
Loading...
