Disassembly/Reassembly 8-5TP-5648 8/93
19. Remove the end bracket by bumping the end
bracket flanges with a soft rubber mallet. See
Figure 8-14.
Figure 8-14. Removing the End Bracket
20. Carefully remove the stator by pulling the stator
over the rotor assembly. See Figure 8-15.
NOTE
Due to the heavy weight, it is recommended that
the stator be supported by a hoist during removal
to prevent damage to the stator, rotor, and/or
armature drive disks.
Figure 8-15. Removing the Stator
21. Remove the eight screws and four spacers
securingthegenerator fan.Thencarefullyremove
the cooling fan. See Figure 8-16.
Figure 8-16. Removing the Generator Cooling Fan
22. Support the rotor assembly with a strap andhoist.
Remove the eight screws securing the armature
drive disks to the engine using a 13-mm socket
wrench and ratchet. Remove the rotor assembly
and place it on a bench. See Figure 8-17.
Figure 8-17. Removing the Rotor Assembly
To Next Page
Loading...
