Maintenance
Exhaust gas aftertreatment system (depending on configuration)
u Tighten the filter to 35
±5
Nm (26
±4
ft-lb).
or
Tighten the filter by hand until the filter is in contact with the filter bracket, then use the
filter spanner to tighten the filter an additional 120°.
Fig. 86: Installing the heating mat
u Install the heating mat on the filter.
Fig. 87: Installing the heating mat screws
u Install the heating mat screws (M6).
u Tighten the heating mat screws to 6
±1
Nm (4
±1
ft-lb).
KD62V12 33521030301_8_1 EN_US 2022-09
© 2022 by Kohler Co. All rights reserved.
139
To Next Page
Loading...
