Contents
5.10.3 Inspecting low temperature circuit (charge air cooler) — SL002
126
5.10.4 Checking relief bores — coolant pump — SL003
127
5.10.5 Bleeding the HT/LT coolant system
128
5.11 Fuel system
132
5.11.1 Draining off water from fuel pre-filter — SL004
132
5.11.2 Draining off water and sediment of fuel tank
132
5.11.3 Replacing main filter - SL105
132
5.11.4 Bleeding the fuel system
133
5.11.5 Checking differential pressure — fuel pre-filter — SL005
133
5.12 Air system
134
5.12.1 Checking service indicator on air filter — SL006
134
5.12.2 Replacing crankcase breather — SL107
134
5.12.3 Inspecting engine by-pass flap — SL1-5461 (depending on
configuration) 135
5.13 Exhaust gas aftertreatment system (depending on configuration)
136
5.13.1 Replacing diesel exhaust fluid filter — SL1-5320
136
5.14 Lubricants and operating fluids
141
5.14.1 Handling lubricants and operating fluids
141
5.14.2 Approved diesel fuels, diesel exhaust fluids (DEF), and fuel additives
142
5.14.3 Approved lubricating oils and lubricating oil additives
147
5.14.4 Approved coolants
153
5.15 Filling volume
157
6 Operating faults
158
6.1 Diagnosis principles
158
6.2 Faults - Cause - Remedy
159
7 Tools and devices
164
7.1 Tools
164
7.1.1 Special tools
164
7.1.2 Turning device
167
8 Appendix
170
8.1 Technical design documents
170
8.2 Error code
171
8.3 Cleaning agents, thread-locking adhesives and greases
183
KD62V12 33521030301_8_1 EN_US 2022-09
© 2022 by Kohler Co. All rights reserved.
15