Kohler KD62V12 Operation And Maintenance Manual

Maintenance
Inspection and maintenance schedules
Task identification
Component
Schedule
Service
Type
Task description
Time limit (h)
Calendar limit (year)
Replacement Overhaul Inspection/Clean Repair/Adjustment
SL106
Recommended:
Fuel pre-filters
1000 2Y X
Replace primary fuel filter cartridge.
See the operator and maintenance manual of your
application.
SL107 Oil separator filters 7500 2Y X
Replace oil separator filters. (For more information
see: 5.12.2 Replacing crankcase breather — SL107,
page 134.)
SL108
Recommended: Air
filters + Air ducting
3000 2Y X
Replace the air filter and clean air ducting between
air filter and compressor.
See the operator and maintenance manual of your
application.
SL109 Alternator belt 1500 2Y X X
Inspect conditions of drive belt and fit new one if
necessary. (For more information see:
5.8.1 Removing the battery charging alternator
cover, page 106.) Check belt tension. (For more
information see: 5.8.3 Replacing drive belt — SL 109,
page 108.)
SL110
Alternator belt
tensioner
1500 18Y X
Visual inspection of the tensioner. Replacement if
necessary. (For more information see: 5.8.4
Replacing tensioning device — SL110, page 109.)
SL116 Cooling system 6000 4Y X
Replace coolant (at least every 4 years for coolant
formulated with Glysantin G48).
Respect fluids and lubricants specifications. (For
more information see: 5.14 Lubricants and oper‐
ating fluids, page 141.)
Note: for coolant formulated with Glysantin G40,
the extension up to 8000h/6Y is possible after
analysis. (For more information see:
5.10.2 Replacing coolant — SL116, page 123.)
SL1-53
20
Diesel exhaust
fluid filter
1500
3)
0.5Y X
Replace filter according to time limit or calendar
limit or if required by service tool indication. (For
more information see: 5.13.1 Replacing diesel
exhaust fluid filter — SL1-5320, page 136.)
SL1-53
10
Diesel exhaust
fluid
- - X
Change diesel exhaust fluid at an interval
according to the specification.
SL1-54
61
Engine by-pass
flap
3000 2Y X
Inspect overall condition including proper func‐
tioning of the flap. (For more information see:
5.12.3 Inspecting engine by-pass flap — SL1-5461
(depending on configuration), page 135.)
Tab. 20: Service level 1 — PRP — Basic maintenance - Version: 2021-07
3)
The warning alarm for filter change will occur at 1300h. Filter must be replaced before 1500h
in order to avoid engine shutdown.
KD62V12 33521030301_8_1 EN_US 2022-09
© 2022 by Kohler Co. All rights reserved.
95

Kohler KD62V12 Specifications

General

Brand	Kohler
Model	KD62V12
Category	Engine
Language	English