4
INFORMATION ABOUT USE
EN 26
4.5 Oil filling
•
For safety precautions see Par. 2.4.
•
Before proceeding with operation, read Par. 3.2.2.
•
Do not use the engine with the oil level below the minimum.
1.
Loosen the oil filler cap A or the oil filler cap C if the
cap A is not accessible.
2.
Add the type of oil recommended (Tab. 2.1 and Tab.
2.2).
Fig 4.1
1.
Before checking oil engine needs to be level.
2.
Remove the oil dipstick B and check that the level is
up to but does not exceed the MAX .
3.
If level is not at the MAX . level, add additional oil.
4.
Re-tighten the cap A or C.
Fig 4.2
NOTE: Click on the right to play the procedure.
https://youtu.be/A5WuDZuItu4
4.6 Coolant filling
•
Before proceeding with operation, read Par. 3.2.2.
Warning
•
An anti-freeze protection liquid (ANTIFREEZE) - mixed with decalcified water - must be used.
•
The freezing point of the refrigerant mixture depends on the amount concentration in water.
•
As well as lowering the freezing point, the antifreeze also raises the boiling point.
•
A 50% mixture is recommended to ensure a general level at protection prevents the formation of
rust, galvanic currents and calcium deposits (Tab. 2.4).
To Next Page
Loading...
Need help?
General