INFORMATION ABOUT MAINTENANCE
5
35
EN
Internal Communication: For internal & partner use only.
5.10 Check Poly-V alternator belt
•
Before proceeding with operation, read Par. 3.2.2.
Danger
•
For safety precautions see Chap. 3.
NOTE
: The poly-v belt is not adjustable.
1.
Check the belt A condition, if worn out or deteriorated,
replace it.
NOTE: Make sure that the ribs of the belt A are inserted
correctly into the grooves of the pulleys B (as shown in Fig.
5.14 and Fig. 5.15).
2.
Start the engine and run it for some minutes, then turn
off it, and let it cool down at ambient temperature.
Check by the appropriate tool that at point p the
tension value is between 149 and 196 Hz.
NOTE : If the poly-v belt tension results out of the above
mentioned values contact KOHLER authorised workshops for
Fig 5.14
Fig 5.15
5.11 Check fuel filter cartridge
•
Before proceeding with operation, read Par. 3.2.2.
Danger
•
For safety precautions see Chap. 3.
1.
Gently loosen the water drain plug A without removing
it.
2.
Spill out the water if present.
3.
Re-tighten the water drain plug A as soon as the fuel
spills.
Fig 5.10
To Next Page
Loading...
Need help?
General