TP-5672 11/95 Introduction i
Introduction
This manual covers the operation, troubleshooting,
repair, and service parts for the M340+ microprocessor
logic controller.
Read through this manual and carefully follow all
procedures and safety precautions to ensure proper
transferswitchoperationandtoavoidbodilyinjury.Keep
this manual with thetransfer switch for future reference.
Service requirements are minimal but are very
important to the safe and reliable operation of the
transfer switch; therefore, inspect associated parts
often. It is recommended that an authorized service
distributor perform required servicing tokeeptheswitch
in top condition.
All information foundin this publication is based ondata
availableattimeofprinting. The manufacturer reserves
the right to make changes to this literature and the
products represented at any time without notice and
without incurring obligation.
List of Related Manuals
The logic controller covered in this manual is part of a
family of related devices. Separate service and parts
manuals are available for each group within the overall
family. Be surethis manualis thecorrect manual for the
automatic transfer switch.
A power conversion unit is included in each automatic
transfer switch. There are three types of power
conversion units and eachtypeis covered in a separate
service and parts manual. Available power conversion
units and the related manual numbers are as follows:
Power Switch Device
Service/
Parts Manual
Mechanically held or
electrically held contactors
TP-5667
Molded-case circuit breakers
or switch
TP-5666
Standard contactor,
programmed transition, and
Bypass-Isolation
TP-5668
Service Assistance
For sales and service in the U.S.A. and Canada check
the yellow pages of the telephone directory under the
headingGENERATORS—ELECTRICforanauthorized
service distributor/dealer or call 1-800-544-2444.
KOHLER CO., Kohler, Wisconsin 53044 U.S.A.
Phone: 920-565-3381
Fax: 920-459-1646 (U.S.A. Sales)
920-459-1614 (International)
To ensure supply of correct parts or information, make
note of the following identification numbers in the
spaces provided:
PART NUMBER AND SERIAL NUMBER
Part and serial numbers are provided on thenameplate
attached to the transfer switch.
Part No.
Serial No.
To Next Page
Loading...
Need help?
General
