What to do if my Koldfront WAC12003WCO is cooling but the room is too warm and no ice is forming?
If your Koldfront Air Conditioner is cooling, but the room remains too warm without ice forming, start by cleaning the air filter as a dirty filter can restrict airflow. If that doesn't solve the issue, try setting the temperature to a lower setting.
What to do if Koldfront WAC12003WCO Air Conditioner is cooling but the room is too warm and ice is forming?
If your Koldfront Air Conditioner is cooling the room, but the room is too warm and ice is forming on the cooling coil, try setting the unit to FAN ONLY mode to defrost the coil. Also, clean the air filter, and set the temperature to a higher setting.
Why is my Koldfront Air Conditioner cooling but the room is too warm, and there is no ice forming?
If your Koldfront Air Conditioner is cooling but the room is too warm and no ice is forming, make sure that the air directional louvers are positioned for better air distribution. Clear any obstructions like drapes, blinds, or furniture blocking the front of the unit. Close any open doors or windows to prevent cold air from escaping. If you've just turned it on in a hot room, allow extra time for the unit to remove stored heat from the room.
Why doesn't the air from my Koldfront Air Conditioner feel cold enough?
If the air from your Koldfront Air Conditioner doesn't feel cold enough, it might be because the room temperature is below 17°C (62°F); cooling may not occur until the room temperature rises above this. If the compressor shuts off when changing modes, wait approximately 3 minutes for it to restart in COOL mode. Also, check if the temperature sensing element is touching the cold evaporator coil behind the air filter; if so, straighten the tube so it's not touching the coil.
What to do if my Koldfront WAC12003WCO is not functioning at all?
If your Koldfront Air Conditioner isn't working, first, ensure it's properly plugged into the wall. If it is, check the LCDI power cord and press the Reset button. Also, verify that the house fuse hasn't blown or the circuit breaker hasn't tripped; replace the fuse or reset the breaker if needed. Make sure the control panel is turned on and set to your desired settings. Finally, try moving the unit to another outlet to rule out insufficient power.
Why does my Koldfront WAC12003WCO turn on and off rapidly?
If your Koldfront Air Conditioner turns on and off rapidly, begin by cleaning the air filter. If the outside temperature is extremely hot, try setting the fan speed to a higher setting to increase airflow over the cooling coils.
What to do if the remote is not sensing my Koldfront WAC12003WCO?
If your Koldfront Air Conditioner remote isn't sensing, make sure the remote control is within 16 feet and within a 180-degree radius of the front of the unit. Also, check for and remove any obstructions that might be blocking the remote control signal.
Why is there noise when my Koldfront WAC12003WCO is cooling?
If your Koldfront Air Conditioner is making noise when cooling, some air movement sound is normal; if it's too loud, try setting it to a slower fan setting. If there's window vibration, refer to the installation instructions or check with the installer to ensure proper installation.
What to do if there is water dripping inside my Koldfront WAC12003WCO Air Conditioner when it is cooling?
If your Koldfront Air Conditioner is dripping water inside when cooling, it might be improperly installed. Tilt the air conditioner slightly to the outside to allow for water drainage.
How to fix if the room is too cold with my Koldfront WAC12003WCO Air Conditioner?
If your room is too cold when using the Koldfront Air Conditioner, try increasing the set temperature.
General| Type | Window Air Conditioner |
|---|---|
| Cooling Capacity | 12000 BTU |
| Energy Efficiency Ratio (EER) | 10.9 |
| Voltage | 115V |
| Weight | 76.7 lbs |
| Fan Speeds | 3 |
| Control Type | Electronic |
| Display | LED |
| Remote Control | Yes |
| Filter Type | Washable |
| Refrigerant | R32 |
| Features | Sleep Mode |
| Coverage Area | 550 sq ft |
| Cooling Area | 550 sq. ft. |
| Power Supply | 115V/60Hz |
| Noise Level | 56 dB |
Guidelines for safe operation and handling of electrical components.
Precautions for safe usage, child supervision, and unit placement.
Procedure for positioning and securing the air conditioner unit into the window.
Explanation of the functions of each button on the air conditioner's control panel.
Description of different operating modes like Auto, Cool, Dry, and Fan.
Step-by-step guide to cleaning the air filter for optimal performance and longevity.
To Next Page