Komptec KT-90E - Maintenance Plan

KT-70E / KT-90E / KT-70SE User Manual Page 40 of 59 24 April 2018
10.2. Maintenance Plan
For the first time after 25 operating
hours
Chapter
Date
Signature
Check function and tightness of the filling
hose valve
- -
Check O-ring seal
- -
Check V-belt tension
- -
Oil change
10.4.3
Check tightness of all cooler and connect-
ing lines
- -
Check fastening of the cooler
- -
Final pressure gauge must be located in the
unpressurized state to the 0 position
10.4.4
Tighten valve cap screws and valve pin
screws.
Daily
Chapter
Date
Signature
Check oil level
10.4.1
After 10 Hours (See 8.3)
Chapter
Date
Signature
Change filter
10.4.2
Check O-rings on the filter
- -
Every 500 Operating Hours
Chapter
Date
Signature
Oil change
10.4.3
Change O-rings on the filter
- -
Change O-rings on the cylinder cover
- -
Clean the filter unit
- -
Check safety valve
10.4.5
check exhaust
- -