33
7-5 Resetting the circuit protector
If an overcurrent or short circuit occurs, the circuit protector will be automatically
actuated to protect the electric circuits of the game machine. When resetting the
circuit protector, turn OFF the main power switch, unplug the power cord from the
receptacle, eliminate the cause, and then press the button of the circuit protector.
•Before resetting the circuit protector, be sure to turn OFF the main power
switch and unplug the power cord from the receptacle.
•If the circuit protector trips soon again, immediately turn OFF the main
power switch, unplug the power cord, and contact your nearest dealer.
•The machine has some high-voltage parts inside. Only a qualified
industry specialist is allowed to open the back door of the machine. With
this back door open, be very careful not to touch unnecsessary parts.
•If the machine is in abnormal conditions and does not operate normally,
immediately turn OFF the power switch, unplug the power cord from the
receptacle and contact your nearest dealer.
How to reset the circuit protector
7 Maintenance
1 Be sure to turn OFF the main power
swith and unplug the power cord
from the receptacle.
2 Remove the cause of the trouble.
Press the button on the circuit
protector of the power unit.
Circuit protector(10A)
Power unit
To Next Page
Loading...
