Konami Mocap Boxing - Operation Precautions

Precautions for use
*Be sure to use indoor wiring for within the specified voltage
ran
cord, use indoor wiring of the specified rating or more.
.Failure to do so could result in fire or equipment failure.
-Be sure to use the attached power cord.
.Otherwise a fire or machine trouble may result.
*Never plug more than one cord at a time in the electrical receptacle.
.Doing so could result in fire or electrical shock.
*Do not lay the power cord where people walk through.
You may t
over them.
,You may stumble down and get injured, or damage the power cord.
*Be sure to ground this product.
,Otherwise an electric shock or machine trouble may be caused.
*The sensor frame weighs about 11 kg (24.3 lb).
Be sure to make a team
people in detaching and attaching it and to use a stepladder for
.Otherwise, an injury or accident may result.
Dropping the sensor frame ma
and/or the frame itself damaged.
*Keep the specified clearances (see page 11) between the game
math
as well as other products.
,Otherwise the machine (s) cannot be ventilated well, resulting in malfuncti
*Do not apply a strong force for moving the machine.
,Otherwise, it may result in an accident or breakage of the units.
*Do not leave anything that would Interfere with playing the game.
,This may not just stand in the player’s way but also cause an accident or
space open enough for the player’s body not to hit against nearby walls or o
*Do not change the DIP switch setting of this product to other than fa
.Otherwise, the game can not be played property.
8
8
Q
8
*If there is any abnormaltty such as smoke, bad smell or abnormal rloise being
emitted from the machine, Immediately turn OFF the main power switch and unplug
the power cord from the receptacle to stop operating it.
e
:
Using the machine in abnormal conditions could result in fire or accidents.
In case of abnormality
1 Turn OFF the main power switch.
2 Unplug the power cord from the receptacle.
3 Contact your nearest dealer.
*Do not leave the power cord plugged improperly or covered with dust.
‘Doing so could result in elect&al shock or fire, so inspect the power cord monthly or more
8
frequently.
*Do not hit against the glass surface and the machine body.
,An accident may happen and you may get injured.
4