Administrator Settings (G3)
10
10-14 bizhub 652/552
10.4
10.4 Administrator Settings (G3)
This section describes administrator settings that are configured for G3 Fax TX. The descriptions in this sec-
tion also apply to Network Fax.
10.4.1 System Settings - Power Save Settings
Select the condition on which the machine shifts to the power save mode.
10.4.2 System Settings - Output Settings - Print/Fax Output Settings - Fax
Specify the printing method for RX documents.
- [Batch Print] (default): Printing is started after all documents are received.
- [Page Print]: Printing is made each time a page of document is received.
Item Description
[Enter Power Save
Mode]
Select the condition on which the machine shifts to the power save mode.
• [Normal]: When a fax is received during the power save mode, the fax job
is printed. After a predetermined time has elapsed, the machine shifts to
the power save mode.
• [Immediately] (default): When a fax is received during the power save
mode, the fax job is printed and then the machine immediately shifts to
the power save mode.
To Next Page
Loading...
Need help?
General
