bizhub 652/552 12-7
12.3 Error messages displayed
12
12.3 Error messages displayed
If the machine encounters a problem, an error dialog will appear and display one of the following error mes-
sages. Take corrective actions by referring to the table below.
If a communication error persists, please contact your service representative.
12.3.1 G3 Fax
12.3.2 If the HDD Ready indicator indicates an HDD malfunction
Contact your service representative.
Error Message Corrective Actions
[Failed to complete the
job due to an error while
dialing.]
Redial was attempted the number of times specified, however, transmission
failed because the recipient was busy or due to other reasons.
Check the recipient's state to resend the fax.
[Unable to check send-
er.]
The machine failed to verify the recipient with Check Dest. & Send set to
[Yes].
Check that the receiver's fax number is registered correctly.
[Not enough memory to
continue scanning.]
During scanning of original, the memory became full.
Press Start to send scanned originals. Press Stop to stop faxing.
[Transmission failed.
Please check line con-
nection.]
The telephone cord may have become unplugged.
Check the telephone cord for connection and, if unplugged, plug it securely.
[Cannot connect to the
network.]
Make sure that the network cable is correctly connected. In addition, make
sure that [Network Settings] in Administrator Settings is correctly configured.
[The address for the
communication method
cannot be selected since
the number of addresses
has exceeded the maxi-
mum allowed for broad-
casting.]
The number of destinations specified exceeds the number possible for a
broadcast transmission. Reduce the number of broadcast destinations, or
send the transmission in multiple batches.
[Document could not be
saved in the User Box
due to insufficient HDD
capacity. Check log.]
The hard disk is full. Delete unnecessary data, and then try saving the data
again.
[The number of regis-
tered user boxes has
reached the maximum
allowed.]
The number of User Boxes that can be registered has reached the maximum
number possible. Delete unnecessary User Boxes, and then try registering
new boxes again.
[This user box has
reached its maximum
number of pages al-
lowed.]
The number of documents that can be saved in a User Box has reached the
maximum number possible. Delete unnecessary documents, and then try
saving the document again.
[The maximum number
of jobs has been queued.
Wait until a queued job is
completed.]
The number of jobs that can be programmed has reached the maximum
number possible. Wait until a job has been completed, or delete a current job.
To Next Page
Loading...
Need help?
General
