Administrator Settings (G3)
10
10-24 bizhub 652/552
10.4
2/2 page
Memory RX Setting
Specify whether to use Memory RX Setting function. To use the function, specify a password for print.
Press [No] to clear the entered setting and then specify a password using the keypad. (up to 8 digits)
The following screen is displayed if two units of the Fax Kit FK-502 are installed, and [Individual Receiving
Line Setup] is set to [ON] in Administrator Settings.
Item Description
[Confirm Address (TX)]
(G3)
When specifying a fax destination with direct input, a screen appears
prompting you to enter the fax number again for confirmation. Entering the
fax number twice prevents one from entering incorrect destinations.
• When Confirm Address (TX) is enabled, you cannot specify a destination
using [Off-Hook]. You cannot specify the fax address using [Job History]
either.
[Confirm Address (Regis-
ter)] (G3)
When the user specify a fax destination when the user registers a program,
configures the fax forwarding settings, or registers a one-touch destination,
the user must enter the destination twice for confirmation. By entering twice,
you can prevent the destination from being incorrectly entered.
To Next Page
Loading...
Need help?
General
