bizhub 751/601 (Version 2) 12-55
Utility mode
12
12.6.6 Punch Unit Horizontal Position Adjustment
The horizontal position of punched holes when printing with a Punch setting can be adjusted.
2
Note
[Punch Unit Horizonal Position Adjustment] appears only if optical Z folding unit is installed.
For details on the Punch settings, refer to "Punching holes in copies (Punch settings)" on page 3-74.
0 Before making any adjustments, use a Punch setting to print a sample copy. Perform the adjustment
while checking the sample that was created.
1 Display the Administrator Settings screen.
– For details on displaying the Administrator Settings screen, refer to "Displaying the Administrator
Settings screen" on page 12-42.
2 Touch [1 System Settings].
The System Settings screen appears.
3 Touch [7 Expert Adjustment].
The Expert Adjustment screen appears.
4 Touch [5 Finisher Adjustment].
The Finisher Adjustment screen appears.
5 Touch [6 Punch Unit Horizontal Position Adjustment].
The Punch Unit Horizontal Position Adjustment screen appears.
6 Check the horizontal position of the punched holes.
– To increase width A, touch [+] to increase the adjustment (between 0.1 mm and 5.0 mm).
– Each time [+] or [-] is touched, the value is increased or decreased by one increment.
A
To Next Page
Loading...
Need help?
General
