12
Utility
12-62 C252
Utility Chapter 12
The center stapling position is adjusted.
If the stapling position was at the center of the paper in step 7, this
completes the procedure.
9 Use the “Fold & Staple” function to print a another sample copy.
10 Check the print result.
– Check that the stapling position is adjusted to the center of the pa-
per.
– If more adjustment is necessary, repeat steps 1 and 9.
2
Note
If the angle of the staple must be adjusted, contact your technical repre-
sentative.
For details on adjusting the center folding position, refer to “Adjusting the
center folding position” on page 12-58.
2
Note
Enter the value by mm using the keypad.
Refer to the conversion rate below.
1 in. = 25.4 mm
Adjusting the horizontal punch position
The horizontal position of punched holes when printing with a Punch setting
can be adjusted for each paper type.
0 Before making any adjustments, use a Punch setting to print a sample
copy. Perform the adjustment while checking the sample that was creat-
ed.
1 Display the Administrator Setting screen.
– For details on displaying the Administrator Setting screen, refer to
“Displaying the Administrator Setting screen” on page 12-47.
2 Touch [1 System Setting].
The System Setting screen appears.
3 Touch [7 Expert Adjustment].
The Expert Adjustment screen appears.
To Next Page
Loading...
Need help?
General
