2
Preparation for Use
2-36 bizhub PRO C6501
2.3 Automatically Returning to the Default Settings: Auto-
matic Reset Setting
Without the [Reset] key pressed on the control panel, the machine automat-
ically clears all the copy settings specified so far and restores the default set-
tings after a certain period of inactivity.
This function is called Automatic Reset Setting.
As a factory default, Automatic Reset Setting is programmed to function after
1 minute of machine inactivity. The timespan for this operation can be
changed in the Utility mode.
Either Full-auto or Initial can be selected as default.
Copy settings specified as Full-auto are as follows. These settings cannot be
altered except the Output Application setting.
- Original Setting: Normal
- Color: Full color
- Zoom: 1.000
- Application: None
- Quality Adjustment: Standard
- Output Application: Selection available in the Utility mode
- Simplex/Duplex: 1->1
- Paper Setting: Auto
!
Detail
For selecting the timespan for the Automatic Reset Setting, see page 5-
17 of the POD Administrator’s reference.
For changing Output Application setting in Full-auto, see page 5-40 of
the POD Administrator’s reference.
!
Detail
For selecting the timing to resume machine defaults apart from Automat-
ic Reset Setting, see page 5-17 of the POD Administrator's reference.
To change the default settings to be resumed when the machine is reset,
see page 5-19 of the POD Administrator's reference.
To change the selection of Output Application for Full-auto, see page 5-
40 of the POD Administrator’s reference.
To select the copy conditions to be reset with each job completion, see
page 5-19 of the POD Administrator's reference.
To Next Page
Loading...
Need help?
General
