Installing the TWAIN Driver
3
Di1611/Di2011 Twain Driver 3-3
Installing the TWAIN Driver Using Plug and Play Under Windows
2000
1 With Windows running, insert the CD-ROM into your computer’s CD-
ROM drive.
2 Turn on the copier.
3 When the copier is ready, connect it to the computer with the USB ca-
ble.
The “Found New Hardware Wizard” dialog box appears.
4 Select Search for a suitable driver for my device (recommended)
in the “Install Hardware Device Drivers” dialog box, and then click
[Next].
The “Locate Driver Files” dialog box appears.
5 Select Specify a location, and click [Next].
6 Click [Browse...] on the next dialog box, browse to
“Driver\(language)\Win2000” on the CD-ROM, and then click [OK].
Tip
Select the language you prefer. For example, if you prefer English,
browse to:
Driver\English\Win2000
7 Click [OK], and follow the instructions that appear on the screen until
the “Completing the Found New Hardware Wizard” dialog box ap-
pears.
H Click [Finish].
8 The “Found New Hardware Wizard” dialog box appears again.
H Repeat steps 4 through 7.
Note
This completes the installation of the TWAIN driver.
To Next Page
Loading...
Need help?
General
