Korg drumlogue - Operation Guide; Power Management and Quick Start

11
Operation Guide
Turning the power On/O
Turning the drumlogue On
Make sure that both the drumlogue and any external output devices such as powered
monitor speakers are turned o, and turn the volume of all devices all the way down.
1.
Hold down the Power switch on the rear panel of the drumlogue; once the
“drumlogue” logo appears in the display, take your nger o the Power switch
.
2.
Turn on any external output devices such as powered monitor speakers.
Adjust the volume of your external output equipment, and adjust the drum-
logue’s volume using the VOLUME knob.
Turning the drumlogue O
1.
Lower the volume of your powered monitors or external output system, and
turn them o.
2.
Hold down the Power switch on the rear panel of the drumlogue; to turn o
the power after the display goes blank, take your nger o the power switch.
Once you have turned the drumlogue o, wait about 10 seconds before
turning the drumlogue on again.
Auto Power O Feature
The drumlogue features an Auto Power O feature that can automatically turn the drum-
logue o after 4 hours have elapsed with no operation of the knobs, switches, or buons
of the drumlogue. By default, the factory seing for the Auto Power O is enabled.
The Auto Power O can be disabled using the steps below.
To disable the Auto Power O feature
1.
While holding down the SHIFT buon, press the LIVE buon to enter
GLOBAL mode.
2.
Press the DELAY buon to enter the “HW SETTINGS“ page.
TIP
You can also move pages by pressing the PAGE UP/DOWN buon repeat edly.