26
Sound Source Parameters
Analog sound source parts (BD, SD, LT, HT)
BD (Bass drum)
Control knob
DECAY [0...1023]
Adjusts the sounding length of the drumhead.
The greater the value, the longer the sound.
TUNE [0...1023]
Adjusts the pitch of the bass drum.
DRIVE [0...1023]
Adjusts the distortion amount of the bass drum. A fat sound is created by moder-
ately distorting the bass drum.
SOUND SELECT
TRANSIENT [01..16]
Select a bass drum transient.
A short PCM sample is layered on the BD analog sound source, which is referred to
as a transient. A transient allows you to change the character of the BD aack tone.
PARAMETERS
SWEEP [0.0%...100.0%]
Adjusts the level of the sweep (which changes the pitch when triggered).
SW.TIME [0.0%...100.0%]
Adjusts the sweep speed.
HOLD [0...3]
Sets the time period to keep sounding at a constant volume.
ATTACK [0.0%...100.0%]
Adjusts the level of the transient sound.
CUTOFF [L0.0%...L99.5%, THRU, H0.5%...H100.0%]
Adjusts the cuto frequency of the lter.
You can select the low-pass lter, no lter (THRU), or the high-pass lter.
To Next Page
Loading...
