Korg drumlogue - Sequencer Operations; Sequencer Transport Controls

16
Using the Sequencer
Transport
Playing and stopping a pattern (During pattern edit)
When you press the STEP buon, the following is displayed.
As in Live mode, press the (PLAY) buon to play or stop the paern. You can
pause a paern by pressing the
(PLAY) buon while holding down the
SHIFT buon.
Changing the tempo
(→ p.13 "Changing the tempo")
Time and groove
To change the timescale for the clock or edit the number of steps in the paern,
turn the parameter knob while holding down the TIME buon. You can also set
each part by pressing the TIME buon while holding down the PART buon.
RATE [Global (only the part setting), 32nd, 16th, 8th]
Changes the playback speed of the paern for the clock. The default is 16th. If the
value is set to 8th, the speed is halved, and if set to 32nd, the speed is doubled.
TRIPLET [Global (only the part setting), OFF, ON]
Turn it on to increase the speed by 1.5 times triplets.
LENGTH [1...64]
Allows you to change the paern length in steps.
Also, you can produce various groove feelings by applying the groove type that re-
produces the swing and the playing style of a typical instrument to the paern data.
Press the TIME buon while holding down the SHIFT buon, and turn the param
-
eter knob while holding down the TIME buon. You can also set each part by press-
ing the TIME buon while holding down the SHIFT buon and the PART buon.
TYPE [Global (only the part setting), Swing16, ... , CrescendoHalf]
Select the groove type. The groove type is a 16-step preset template that summa-
rizes the timing and velocity change amount for each step.