Korg drumlogue - Miscellaneous; Restoring the Factory Settings

53
Miscellaneous
Restoring the Factory settings
You can restore the drumlogue’s preset Programs and global seings to their origi-
nal factory-set state at any time.
1.
Begin with the drumlogue turned O.
2.
While holding down the SHIFT buon and the (REC) buon, turn the
drumlogue On.
“FACTORY RESET” will be indicated in the display.
3.
Turn Parameter knob 1, and select a target seing (ALL, GLOBALS, PRO-
GRAMS, SAMPLES, UNITS) to return to the factory default.
ALL: GLOBALS, KITS, PROGRAMS, SAMPLES, and UNITS, all items return to
their factory defaults.
Please note that all data are rewrien to the factory defaults (the saved pro-
grams and drum kits are erased).
GLOBALS: The seings of the global parameters return to their factory defaults.
KITS: The preset kits (drum kits A01 to D16) return to their factory defaults.
This will rewrite the preset kit to factory defaults. If you want to keep the
preset kit, use the KIT SAVE buon to save it in program banks E01 to H16
in advance.
PROGRAMS: The preset programs (programs A01 to D16) return to their fac-
tory defaults.
This will rewrite the preset program to factory defaults. If you want to
keep the preset program, use the PROGRAM SAVE buon to save it in
program banks E01 to H16 in advance.
SAMPLES: The sample bank of USER and EXP returns to the factory default
state.
UNITS: All of the installed logue SDK units (user synth, delay, reverb, master
eects) return to their factory defaults.
4.
Press the
<
(YES) buon.
The display will indicate the message "Are you sure?".
5.
Press the
<
(YES) buon again.
The factory-set default data will be reloaded, and the drumlogue will be re-
stored to its factory default state.
TIP
Press the
<
(NO) buon to cancel.
Never turn o the drumlogue while data is being loaded. Doing so might
damage the internal data.