Korg drumlogue - Page 31

31
DECAY (RS only) [0.0%...100.0%]
Sets the decay time. The greater the value, the longer the sound.
START [0.0%...100.0%]
Sets the start position of sample playback.
END [0.0%...100.0%]
Sets the end position of sample playback.
CUTOFF [L0.0%...L99.5%, THRU, H0.5%...H100.0%]
Sets the cuto frequency of the lter.
You can select the low-pass lter, no lter (THRU), or the high-pass lter.
RESON (CUTOFF RESONANCE) [0.0%...100.0%]
Sets the cuto resonance of the lter.
If you increase the value, the lter oscillates, which may cause the sound to
continue.
REDUX [0.0%...100.0%]
Adjusts the distortion amount due to bit reduction.
DRIVE [0.0%...100.0%]
Sets the distortion amount of the sound source. A fat sound is created by moder-
ately distorting the sound source.
MIX/ROUTE
PAN [L100%...L1%, C, R1%...R100%]
Adjusts the pan pot (left and right stereo localization).
SPREAD [<100%...<1%, 0, >1%...>100%]
Adjusts the spread of sound (stereo feeling).
DELAY [0.0%...100.0%]
Adjusts the feed amount of the delay eect.
REVERB [0.0%...100.0%]
Adjusts the feed amount of the reverb eect.
MASTER [ON, BYPASS]
Sets the master eect to On or Bypass.
SIDECH (SIDECHAIN) [0.0%...100.0%]
Adjusts the feed amount of the SIDECHAIN pass.