47
nector; messages are transmied from the USB B connector and the MIDI OUT connector.
USB: MIDI messages will be transmied and received only via the USB B connector.
MIDI RX (Button 8)
PRG CHG (PROGRAM CHANGE) [OFF, ON]
Selects whether MIDI program change messages will be received. Turn this ON
when receiving messages.
CC (CONTROL CHANGE) [OFF, ON]
Selects whether MIDI control change messages will be received. Turn this ON
when receiving messages.
TRANSP (MIDI TRANSPORT) [OFF, ON]
A lter to receive MIDI transport messages such as MIDI start/stop. Turn this ON
when receiving messages.
MIDI TX (Button 9)
PRG CHG (PROGRAM CHANGE) [OFF, ON]
Selects whether MIDI program change messages will be transmied. Turn this ON
when sending messages.
CC (CONTROL CHANGE) [OFF, ON]
Selects whether MIDI control change messages will be transmied. Turn this ON
when sending messages.
TRANSP (MIDI TRANSPORT) [OFF, ON]
A lter to send MIDI transport messages such as MIDI start/stop. Turn this ON
when sending messages.
SYNC IN (Button 10)
UNIT (SYNC IN UNIT) [8TH, 16TH]
The Sync In Units determine how much the Sequencer will advance with each
pulse received via the SYNC IN jack.
8TH: The Sequencer will advance one eighth note for each pulse.
16TH: The Sequencer will advance one sixteenth note for each pulse.
POLAR [RISE, FALL]
In order to achieve synchronization with other units, the polarity of the SYNC IN
jack may need to be changed.
RISE: The drumlogue will sync to the pulse as it rises to its crest (the highest point)
of the waveform.
FALL: The drumlogue will sync to the pulse as it falls to its trough (the lowest
point) of the waveform.
To Next Page
Loading...
