Korg drumlogue - Page 6

6
(BD, SD, LT, HT), digital sound sources (CH, OH, RS, CP, SP1, SP2), multi-sound
sources (VPM, NOISE, USER), and three eect seings, which can be accessed. In
addition, the LEDs above the 16 buons show the paern’s step information.
6.
VOLUME knob
Adjust the volume of the entire unit. This is useful for L/MONO, R, and head-
phone output.
AUDIO OUT1 to 4 are not aected by activation of this knob.
7.
TEMPO knob
Adjust the tempo of this unit to be between 56.0 and 240.0 BPM.
Tempo information is provided for each program. You can set whether to
use the value saved in the program when switching programs or to give
priority to the value of the current TEMPO knob (→ p.44 "TEMPO").
8.
PAGE UP/DOWN button
If items span over multiple pages when you are editing parameters, use this
buon to proceed to the next page or the previous page.
TIP
The indicator such as "1/2" (rst of two pages) appears in the upper right
corner of the display.
9.
MUTE button
If you press one of buons 1 to 13 (BD~USER) while holding down this buon,
all steps of the part of the buon you pressed are temporarily turned o and
muted. To cancel Mute mode, press the buon(s) assigned to mute from among
buons 1 to 13 while holding down the MUTE buon.
10.
PART button
While holding down this buon, press one of buons 1 to 16 to switch the
drum part and the eect you want to edit. This is eective for paern editing,
etc. In addition, while holding down this buon, press the VPM/NOISE/USER
buon to select which MULTI sound source to use.
11.
SHIFT button
While holding down this buon, operate the knob or buon to which the shift
function is assigned. For example, you can edit HT TUNE (high tom tuning) by
turning the kit control LT TUNE (low tom tuning) knob while holding down
the SHIFT buon.
QUEUEQUEUE
GLOBAL
HYBRID DRUM MACHINE
drumlogue
PROGRAM KIT
PATTERN EDIT
SELECT SAVE SELECT SAVE
LIVE CHAIN LOOP STEP ACCENT MOTION
MUTE
PART
SHIFT
><
PAGE
TEMPO
12
13
14 15
16 17 18 19
22 23 24 25
20
21