Drum Track function settings Drum Track function settings in Combination mode
79
MIDI transmission and reception for the
drum track
In Program mode, the Drum Track function transmits and
receives on the following MIDI channels.
Receive: If you’re controlling the triggering by playing the
keyboard, the drum track will receive on the global MIDI
channel.
Transmit: The drum track will transmit on the MIDI
channel that’s specified by the Drum Track Prog MIDI Ch
(default: channel 10) which can be found on the G-MIDI>
OUT page. (Note data etc. of the Drum Track program will
be transmitted.)
Note: MIDI transmission of the pattern data is enabled if
Drum Track Prog MIDI Out is selected. The default setting
is off (unselected).
The Drum Track program does not transmit or receive
program changes.
Drum Track function settings in
Combination mode
MIDI transmission and reception for the
drum track
In Combination mode, the Drum Track function transmits
and receives on the following MIDI channels.
Receive: If you’re controlling the triggering by playing the
keyboard, the drum track will receive on the global MIDI
channel.
Transmit: The drum track will transmit on the MIDI
channel that’s specified by the Output (C-DRUM TRACK>
CHANNEL) setting of each combination.
Set this to match the MIDI channel of the timbre you’ve
specified for the drum program.
If the timbre’s Status (COMBI> PROG) is EXT or EX2, the
note data etc. of the Drum Track pattern will be transmitted.
Drum Track function settings in
Sequencer mode
The parameters for the Drum Track function are structured
in the same way as in Combination mode. Assign the Drum
Track program to the desired track 1–16.
However, while a combination triggers the Drum Track
pattern on the global MIDI channel, a song triggers the
Drum Track pattern on the MIDI channel specified by the
Input (S-DRUM TRACK> CHANNEL). Normally you’ll
set this to Tch. With the Tch setting, the MIDI channel of the
track selected by Track Select will automatically be used as
the trigger channel.
For details, please see “Selecting a Drum Track pattern and
Drum Track program” on page 78.
In Sequencer mode you can use the Drum Track function
while realtime-recording a song track or pattern.
The note-on/off data transmitted by the Drum Track pattern
can be recorded as events in a track or pattern.
You can’t use note data from the internal sequencer as a
trigger to start patterns for the Drum Track function.
When you’ve used the Drum Track function with a program
or combination to come up with an idea for a song, you can
then use the Auto Song Setup function to immediately start
realtime-recording. (see page 55)
MIDI transmission and reception for the
drum track
In Sequencer mode, the Drum Track function transmits and
receives on the following MIDI channels.
Receive: The drum track will receive on the MIDI channel
specified by the Input (S-DRUM TRACK> CHANNEL)
setting of each song. Normally you’ll set this to Tch and use
the KROSS’s keyboard to control the triggering.
Transmit: The drum track will transmit on the MIDI
channel specified by the Output (S-DRUM TRACK>
CHANNEL) setting of each song. Set this to match the MIDI
channel of the MIDI track where you’ve assigned the drum
program.
If the track’s Status (SEQ> PROG) is BTH, EXT, or EX2,
note data etc. of the Drum Track pattern will be transmitted.
To Next Page
Loading...
Need help?
General
