Korg minilogue User Manual

17
FILTER
VCF: Voltage Controlled Filter
The low-pass lter shapes the tone by selectively ltering cer-
tain parts of the harmonic spectrum of the sound generated
by the Oscillators and the Noise generator.
CUTOFF knob [0...1023]
This knob is used to set the cuto frequency. Harmonic con-
tent above the cuto frequency will be ltered out.
Turning the knob to the left will lower the cuto frequency,
and turning the knob to the right will raise the cuto frequen-
cy.
If the CUTOFF value is set too low, the volume may
be extremely low.
RESONANCE knob [0...1023]
Also known as Peak or Q, the RESONANCE control adds additional emphasis
to the overtones occurring at the CUTOFF frequency, giving a distinctive char-
acter to the sound.
Turning the knob to the right will increase the resonance eect.
TIP
The overtones that are emphasized will change depending on the cut-
o frequency. For this reason, it’s good to adjust the CUTOFF knob
while adjusting the RESONANCE knob.
When emphasizing the overtones in this way, the sound may distort
depending on the cuto frequency or the input audio.
Low resonance value High resonance value

Korg minilogue Specifications

General

Product type	Analog synthesizer
Product color	Silver
User presets quantity	100
Keyboard number of keys	37
Maximum polyphony (notes)	4
Display type	OLED
Built-in display	Yes
Headphone outputs	1
DC input voltage	9 V
Power source type	AC

Weight and Dimensions

Depth	300 mm
Width	500 mm
Height	85 mm
Weight	2800 g