Korg minilogue - Basic Parameter Editing; Oscillator (VCO 1 & 2) Parameters

14
Basic Parameter Editing
In this section, we’ll explain the basic parameters that make up a program.
The basic parameters are assigned to the knobs and switches on the front panel.
VCO 1, VCO 2
VCO: Voltage Controlled Oscillator
There are two oscillators in the minilogue. Os-
cillator Parameters include the seings for the
pitch of the sound (OCTAVE, PITCH) and the
waveform (WAVE, SHAPE).
O C T A V E s w i t c h [ 1 6 ’, 8 ’, 4 ’, 2 ’ ]
The pitch of oscillators 1 and 2 can be set in
octave steps.
WAVE switch [ , , ]
This sets the waveforms for oscillators 1 and 2.
Square wave: This waveform is used for electronic and wind instrument
sounds.
Triangle wave: This waveform has a rounder feel than the sawtooth or square
wave.
Sawtooth wave: This waveform is used to create sounds typical of analog syn-
thesizers, such as synth basses and brass.