Korg Nu Tekt NTS-3 kaoss pad kit - | Changing the routing of an effect module

NTS-3 kaoss pad kit - Parameter edit
25
4 “CLEAr” blinks in the display.
5 Press the knob again to initialize the program.
Tip: You can cancel the operation by turning the knob, pressing the EDIT button or by pressing another
button to enter a different mode.
| Changing the routing of an effect module
ROUTING (routInG) : SErIAL, SErPAr, PArSEr, 1 PArA, 2 by 2, 3 to 1
This shows how to change the routing of the four effect modules for the selected program.
1 Press the EDIT button to enter Program Edit mode.
2 Turn the knob to select “ROUTING”.
Once you see “routInG” in the display, press the knob.
3 Select the routing you wish to change, either “SErIAL”, “SErPAr”, “PArSEr”, “1 PArA”, “2 by 2” or
“3 to 1”.
4 Press the knob again to finish editing.
There are six different routings, as shown below.