Korg Nu Tekt NTS-3 kaoss pad kit - Troubleshooting

NTS-3 kaoss pad kit - Appendices
31
Troubleshooting
Power does not turn on
• Make sure that the included USB cable is correctly plugged in and connected. → Making con-
nections and turning on the power
• Either the AC adapter you’ve connected or the amount of power supply from your computer
may be insufficient. Connect this unit to a USB port that can supply sufficient power.
→ Making connections and turning on the power
No sound, volume is too low or too loud
• Adjust the VOLUME control on the front panel of the NTS-3 kaoss pad kit. → Front panel
• Adjust the volume of your external audio equipment.
• Check whether the audio output jacks (the AUDIO IN jack on the NTS-3 kaoss pad kit and the
audio output jack of your external audio equipment) are correctly connected with a working
cable. → Making connections and turning on the power
• Adjust the input gain on the NTS-3 kaoss pad kit. → Global parameters
• You may not hear sound if the Silent effect is used on one of the four effect modules, depend-
ing on the routing. → Selecting an effect module
, → Effect types, → Changing the routing of an
effect module
Sound is distorted or noisy
• Adjust the input gain on the NTS-3 kaoss pad kit. → Global parameters
Effects cannot be applied
• Make sure that the effects in question are not turned off. If they are off, turn them on and
select an effect. → Selecting an effect module
• If you touch the lowest point of the FX DEPTH control in Perform mode, the effect’s Dry:Wet
parameter may be set to Dry=100%, which negates the effect. Touch the upper part of the FX
DEPTH control while in Perform mode.
Cannot change the effect sound
• The freeze function may have been activated in Perform mode. Long-press the blinking buttons
(FX1–FX4) for the effect module to release the freeze state. → Playing the programs
• The ASSIGN parameter for all effects in Effect Edit mode may have been set to “None”. Try
using the FX Clear function in Effect Edit mode to solve this. → Selecting the module common
parameter and value
The touch pad, FX DEPTH, MUTE button and TEMPO button do not respond
• Try executing the Touch sensor calibration global parameter. → Global parameters