NTS-3 kaoss pad kit - Parameter edit
20
Effect edit mode
This section explains how to use Effect Edit mode.
In Effect Edit mode, you can individually adjust how the effects of the FX1–FX4 effect modules are
applied in response to the touch pad and FX DEPTH control.
|
Editing the effect modules
1 Select the effect module to edit.
EDIT button + FX1–FX4 buttons: selects the effect module to edit
Press the FX1–FX4 buttons while holding down the EDIT button to select one of the effect modules.
The unit enters Effect Edit mode.
2 Select the parameter to edit.
Turn the knob: selects a parameter
Press the knob: confirms the parameter and enters target selection
Turn the knob to select the parameter to edit.
The parameters depend on the effect type that’s currently selected. See the effect type table for Per-
form mode. → Effect types
Press the knob to confirm.
3 Select the parameter target to edit, and set the value.
Turn the knob: selects the target
Touch pad X axis (horizontal): sets the value
FX DEPTH: sets the value
MUTE button: shows the currently set value in the display
Turn the knob: returns to step 2 (parameter selection)
Turn the knob to select the parameter target to edit.
Use the touch pad X-axis (horizontal) or the FX DEPTH control to set the value. → Parameter target
and value
Tip:
Press the MUTE button to show the currently set value in the display.
Tip:
Press the knob to return to parameter selection (step 2), where you can check how the effect actu-
ally works with your settings by using the touch pad and FX DEPTH control.
|
Parameter target and value
You can set six types of targets for each effect parameter.
ASSIGN (ASSIGn): nonE, X, Y, dEPtH
Selects where to assign the parameter change. “none (nonE)” means no setting, “X” means the X-axis
(horizontal) of the touch pad, “Y” means the Y-axis (vertical) of the touch pad, and “depth (dEPtH)”
means the FX DEPTH. Sets the parameter you want to change according to where you touch the
touch pad (or set “none” for parameters you don’t want to change).
To Next Page
Loading...
