Korg prologue - Page 25

25
SHAPE knob [0...1023]
Thisknobwilldeterminethenalshape,complexity,orduty-cycle(Square)ofthe
selected waveform.
MODULATION
Apowerfuloscillatorsync,crossmodulation,andringmodulation
can be applied to the oscillators.
PITCH EG switch [VCO 2, VCO 1+2, ALL]
Select the oscillator and use the EG to modulate its pitch.
VCO 2: Uses the EG to modulate the pitch of oscillator 2.
VCO 1+2: Uses the EG to modulate the pitch of operators 1 and 2.
ALL: Uses the EG to modulate the pitch of operators 1 and 2, as well as the MULTI
ENGINE.
INT knob [-4800...+4800]
Setstheamountofpitchmodulation(howmuchthepitchchanges)forthePITCHEG.
Turning the knob to the right results in a greater change in pitch from the EG.
Referto“EG”(p.34)fortheEGseings.
SYNC/RING switch [RING, o, SYNC]
Theallowsyoutoapplyoscillatorsyncorringmodulatoreectstothesound.
RING:Thisproducesaringmodulationeect.
Oscillator1isusedtoring-modulateOscillator2.ByadjustingthePITCHknobof
Oscillator 2, you can create non-tonal metallic sounds.
o(centerposition):Turnstheoscillatorsyncandringmodulatoro.
0 1023
VCO 2
VCO 1
RING MOD