Korg prologue - Page 27

27
NOISE
Noiseisusedtocreatepercussioninstrumentsounds,orsoundeectssuchassurf.
SelectoneofthefournoisegeneratorsusingtheTYPEknob.
MovetheSHAPEknobtomakechangesinthesound.
OCTAVE switch [2’, 4’, 8’, 16’]
Thekeytrackingeectcanbeadjustedonanoctave-by-octavebasis,onlywhen
“Decim”isselectedwiththeTYPEknob.
TYPE knob [High/Low/Peak/Decim]
Select the noise generator to use.
The noise generator name will be indicated on the MULTI ENGINE display.
High:Ahigh-passlterwillbeused.
Low:Alow-passlterwillbeused.
Peak:Apeaklter(bandpasslter)willbeused.
Decim:ADecimatorwillbeused.
SHAPE knob
Set the noise generator parameter to make changes to the sound.
Theparametersdierdependingonthenoisegeneratorthatyouselectusingthe
TYPEknob,withthefollowingeects.
SHAPE knob eects
Type Parameter SHAPE knob effects
High Cuto [10.0Hz...21.0kHz]
ThisadjuststhecutofrequencyoftheHPF.
Low Cuto [10.0Hz...21.0kHz]
ThisadjuststhecutofrequencyoftheLPF.
Peak Bandwidth [110Hz...880Hz]
Adjuststhepeakcharacteristicbandwidth.
Decim Sample Rate [240Hz...48.0kHz]
Adjuststhesamplerate.