Korg SQ-64 - Parameters for Melody Tracks (A-C); Parameters for Drum Track (D)

20
SQ-64 Owner's Manual
Pad position Global parameter name PARAM knob Value (initial value is in boldface) Parameter details, remarks
PARAM3 MIDI1 OFF, MIDI1 ON
Enable/disable transmission of MIDI transport messages to MIDI1 output.
PARAM4 MIDI2 OFF, MIDI2 ON
Enable/disable transmission of MIDI transport messages to MIDI2 output.
B-15 USB BUS POWER
PARAM1 500mA, 2A
When connecting to a USB 2.0 compliant port, set to "500mA".
C-10 MIDI THRU PARAM1 OFF, ON
Enable/disable MIDI THRU behavior for MIDI2 output. When enabled, the MIDI2 output
becomes a dedicated MIDI THRU port, only relaying all messages received on the MIDI input.
■
When the TRACK button [A] to [C] is pressed
Pad position Global parameter name PARAM knob Value (initial value is in boldface) Parameter details, remarks
A-5 GATE CV PARAM1 V-TRIG, S-TRIG*
Set the polarity of the gate output.
PARAM2 5V, 10V
Set the voltage range for the gate output.
A-6 PITCH CV PARAM1 Hz/V, 0.26V/oct, 0.32V/oct, 1V/oct, 1.2V/oct
Set the pitch CV output mode.
PARAM2 -1.00V - +1.00V (0V) *0.01V increment
Set a voltage bias on the pitch CV output.
PARAM3 0V : 0 - 127 (C3) * display as "note name" Set the reference note for 0V
PARAM4 TEST OUT OFF, TEST OUT 0-127 * display note
names
Enable/disable a test signal on the pitch CV output. When enabled the voltage
corresponding to the specied note will be set on the pitch CV output.
A-7 MOD CV PARAM1 0.00V - 10.00V (5V)
Set the voltage range for the mod CV output.
PARAM2 -1.00V - +1.00V (0V) *0.01V increment
Set a voltage bias on the mod CV output.
PARAM4 TEST OUT OFF, TEST OUT 0-127
Enable/disable a test signal on the mod CV output. When enabled the voltage
corresponding to the specied value will be set on the mod CV output.
A-9 MIDI RX PARAM1 CH1 - CH16 (A: CH1, B: CH2, C: CH3)
Set channel on which MIDI messages will be received.
PARAM2 USB OFF, USB ON
Enable/disable reception of MIDI messages from USB-MIDI.
PARAM3 MIDI OFF, MIDI ON
Enable/disable reception of MIDI messages from MIDI input.
A-10 MIDI TX PARAM1 CH1 - CH16 (A: CH1, B: CH2, C: CH3)
Set channel on which MIDI messages will be transmitted.
PARAM2 USB OFF, USB ON
Enable/disable transmission of MIDI messages to USB-MIDI.
PARAM3 MIDI1 OFF, MIDI1 ON
Enable/disable transmission of MIDI messages to MIDI1 output.
PARAM4 MIDI2 OFF, MIDI2 ON
Enable/disable transmission of MIDI messages to MIDI2 output.
* V-TRIG, or voltage trigger, means the signal will be high when active and low when inactive. S-TRIG, or switch trigger, means the signal will be low when active and high when inactive.