EasyManuals Logo

Korg STAGEMAN 80 User Manual

Korg STAGEMAN 80
144 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #13 background imageLoading...
Page #13 background image
Quick Start
13
Quick Start
This quick start section explains the basic functionality of the
STAGEMAN 80. Start by reading this chapter to understand
the basic functions; then read the subsequent chapters to
delve in deeper.
Listening to the demo
performances
The STAGEMAN 80 contains demo song data. Let’s start by
listening to the sound of the STAGEMAN 80.
1
4
3
1
2
1. Simultaneously press the [SYSTEM] buon and [Count
Start] buon to enter Demo mode.
The [SYSTEM] buon and [Count Start] buon blink, and
the demo song plays.
The top panel buons light in synchronization with the
demo song.
2. Use the VOLUME knob to adjust the volume of the
demo song.
3. You can press the [
] or [ ] buons to play the
previous or next demo song.
4. To exit Demo mode, press any one of the mode buons
[RHYTHM], [RECORDER], [PLAYER], or [SYSTEM].
Connecting and playing
instruments
The STAGEMAN 80 provides a mic input, two inputs for guitar
or bass, and an AUX input, allowing multi-channel mixing. A
variety of input sources are supported, including guitar, bass
guitar, and a microphone.
Playing guitar
Here’s how to connect a guitar.
5
6
1,2
1
1,3
4
1. Set the (INPUT) 1 knob and the VOLUME knob to
the minimum position, and connect your guitar to the
INPUT 1 jack.
2. Use the (INPUT) 1 knob to adjust the input level.
To avoid signal clipping (signal that’s too loud) this knob
should be adjusted so that the peak LED doesn’t light up
when signal is being loudly input.
3. While playing your guitar, use the VOLUME knob to
adjust the volume that is output from the speakers.
4. Use the TREBLE knob and BASS knob to adjust the
tone.
5. As necessary, use the REVERB knob to adjust the eect.
You can apply a reverb eect to the signals from the MIC
IN jack, INPUT 1 jack, and INPUT 2 jack.
Tip: If you’re using a VOX VFS5 foot switch, you can use
it to turn reverb on/o.
6. If you enable the Acoustage function by pressing the
[ACOUSTAGE] buon, the audio output from the
STAGEMAN 80 will be heard in an expansive stereo
eld.
When the Acoustage function is enabled the wide stereo
eect will be applied to all audio signals output from the
STAGEMAN 80.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Korg STAGEMAN 80 and is the answer not in the manual?

Korg STAGEMAN 80 Specifications

General IconGeneral
BrandKorg
ModelSTAGEMAN 80
CategoryDrums
LanguageEnglish

Related product manuals