6
[D], [E], [F], [G], or [H] keys will select the EXB-A
(E-A), EXB-B (E-B), EXB-C (E-C), EXB-D (E-D),
EXB-E (E-E), EXB-F (E-F), EXB-G (E-G), and EXB-
H (E-H) banks. Normally, the external banks are
used to load the included combinations when the
EXB-PCM series options are installed.
When the program of a Combination mode or
Multi mode timbre/track is selected, these keys
are used to select the program bank.
In dialog boxes such as Write Program or Write
Combination, these keys are used to specify the
program or combination bank that will be the
writing destination, etc.
17. Mode keys
Use these keys to enter the desired mode.
When you press a key, the LED will light, and you
will enter the mode whose key you pressed (
☞p.3,
p.34).
[COMBI] key
Combination mode will be selected.
[PROG] key
Program mode will be selected.
[MULTI] key
Multi mode will be selected.
[SAMPLING] key
Sampling mode will be selected
[GLOBAL] key
Global mode will be selected
[DISK] key
Disk mode will be selected.
18. [COMPARE] key
Use this key to compare the edited sound of a pro-
gram or combination with the sound that was
written into memory before editing. This key is
also used in Multi mode when recording a pattern
and to make before- and after-editing compari-
sons. (
☞p.35)
19. CURSOR keys [ –], [ ], [ ], [ +]
Use these keys to select different parameters on
screen.
By holding down the [MENU] key and using cur-
sor keys [ ], [ ] you can switch pages in the
order of 1.1→2.1→2.2→2.3. (
☞p.10)
20. [EXIT] key
In Program, Combination, Multi, Sampling, and
Global modes, pressing this key from anywhere
other than page 1.1 will take you to page 1.1 of that
mode.
When a dialog box is open, this key will cancel the
settings made in the dialog box and close the dia-
log box (corresponds to the “Cancel”). If a Utility
menu or page menu is open, pressing [EXIT] will
close the menu.
21. [MENU PAGE +/–] key
Use this key to select different pages on screen.
When you press this key, a list of the pages within
the mode will appear in the LCD screen. Use [F1]–
[F7] or cursor keys [ ], [ ], [ ], [ ] to select the
desired page, and press the [F8] key to move to the
selected page.
You can also move to a desired page by holding
down the [MENU] key and using numeric keys
[0]–[9] to enter a two-digit page number.
In addition, you can hold down the [MENU] key
and use cursor keys [ ], [ ] to switch pages in
the order of 1.1→2.1→2.2→2.3. (
☞p.34)
VALUE controllers
The following VALUE controllers are used to set
the value of a selected parameter (
☞p.35).
22. [VALUE] dial
Use this to increase or decrease the value of a
parameter. It is convenient to use the dial when
you wish to change the value of a parameter by a
large amount.
23. [INC], [DEC] keys
Use these keys to increment or decrement a
parameter value in steps of one. It is convenient to
use these keys when you wish to change the value
of a parameter in small steps.
17 18
19
20
21
To Next Page
Loading...
