9
Introduction
Objects and functions in the LCD screen
a: Current page
This indicates the currently selected page within
the mode. From the left, this area shows the mode
name, page number:name, tab name, and the
parameter name of the edit cell.
b: Tab
Most pages are divided into two or more tabs. By
pressing the closest function key [F1]–[F7], you can
select a tab to access the corresponding page.
c: Parameters
The parameters for various settings are displayed
in the LCD screen. Use cursor keys [ ], [ ], [ ],
[ ] to select the desired parameter.
d: Edit cell
When you use the cursor keys [ ], [ ], [ ], [ ],
the selected parameter will be highlighted in the
LCD screen. This area is called the edit cell, and
your editing will affect the highlighted area.
The parameter value of the edit cell can be modi-
fied using VALUE controllers such as the [VALUE]
dial or the [INC], [DEC] keys (
☞p.35). For parame-
ters that require you to enter a key or a velocity
value, you can input the value by holding down
the [ENTER] key and playing a note on a con-
nected MIDI instrument.
e: Check box
Use cursor keys [ ], [ ], [ ], [ ] to select a
check box (edit cell), and use a VALUE controller
such as the [VALUE] dial or the [INC], [DEC] keys
to add or remove the check mark.
When checked, the parameter will function, when
unchecked, the parameter will not function.
f: Function buttons
By pressing the function key [F1]–[F8] nearest this
button, you can turn various functions on/off.
:
SW1 and SW2 in Program, Combination, Multi, or
Sampling modes.
, :
Starts/stops pattern recording in Multi mode,
starts/stops sample recording in Sampling mode.
:
Accesses the utility menu where you can execute
utility menu commands.
Other function buttons examples
* Utility menu
In each page, you can press the “UTILITY” func-
tion button (the [F8] key) to access the utility
menu. The utility menu contains commands that
can be used in that page. The utility menu that
appears will differ depending on the page that is
selected.
You can also select up to ten utility menu com-
mands by holding down the [ENTER] key and
pressing a numeric key [0]–[9]. Press the [EXIT]
key to close the utility menu.
For , press the [F7] key to select the desired
utility menu command. You can also use the cur-
sor keys [ ], [ ], [ ], [ ] to make your selec-
tion. For , press the [F8] key to open the
dialog box of the selected utility menu command.
This key also switches the status of commands that
you check or uncheck.
c: Parameter f: Function button
a: Current page d: Edit cell e: Check box
b: Tab
Mode name
Tab name
Page number: name Parameter name
Multi mode: REVERT (copy and paste RPPR
settings)
Sampling mode: INSERT, CUT, COPY, CREATE
(create multisample), L/R,
ZOOM
Global mode: TEXT, KEY+, –
Disk mode: UP, OPEN
Demo: START, STOP
To Next Page
Loading...
