79
Basic functions
Global mode
If you wish to use the settings of another “KEY,”
select the “Copy Key Setup” utility.
0 Select the Voice/Mixer page in GLOBAL 5.1: DKit.
A Set the “Excl Group.”
The “Excl Group” setting is used when you wish to
group drumsamples of the same type.
For example if the note number to which a open hi-
hat and a closed hi-hat drumsample are assigned are
set to the same exclusive group number, they will be
grouped so that the open hi-hat and closed hi-hat
can not be sounded simultaneously, ensuring that
the hi-hat performance will sound natural.
B Use “BUS” to specify the output routing.
Set this when you wish to send the output of the
drumsample assigned to each note number to its
own insert effect or AUDIO OUTPUT (INDIVID-
UAL) jack 1–4.
For example you might set snare-type sounds to
IFX1 and kick sounds to IFX2, so that these sounds
would be sent to insert effects 1 and 2 respectively. If
you wish to send only specific drumsamples to
AUDIO OUTPUT (INDIVIDUAL) jacks 1–4, select
1–4, 1/2, or 3/4.
These settings are valid if “Use DKit Setting” (PROG
7.1: Ed-BUS, BUS page) is checked in the Routing
tab of Program P8 for the program that uses this
drum kit (
☞PG p.27, 143, 144).
C Use “Pan” to specify the stereo output position.
The setting you make here is valid if the “Use DKit
Setting” is checked (PROG 5.1: Ed-Amp1, Level/
Pan page) for the program that uses this drum kit.
D Use “S1 (Send1(MFX1))” and “S2 (Send2(MFX2))”
to set the send levels to the master effects.
The settings you make here are valid if the “ Use
DKit Setting” is checked (PROG 7.1: Ed-BUS, BUS
page) for the program that uses this drum kit.
E Use the “Write Drum Kits” utility to save the data.
If you wish to change the name of the drum kit
before you save it, use the “Rename Drum Kit” util-
ity (☞p.38).
If you turn off the power before writing the data into
memory, your edits will be lost (☞p.39 “Memory in
Global mode”).
To Next Page
Loading...
