Korg TRITON User Manual

15
SetupDemo songs
Combination/Program
Program editingCombination editingArpeggiator editing
Effects and Valve Force
SaplingProducing a song
4
Select the P9: Edit-Master Effect, Master FX page.
Press the [MENU] key to access the page jump
menu, and press the P9: Edit-Master Effect button.
Then press the Master FX tab.
Use “MFX1” and “MFX2” to select the master
effects. You can use the “Chain” check box located at
the left to connect MFX1 and MFX2. “Return1” and
“Return2” adjust the level that is sent from each
master effect to the L/R bus.
You can also use “Low,” “Mid,” and “High” to
adjust the gain of the master EQ.
The parameters of master effects 1 and 2 and the
master EQ can be adjusted in their corresponding
page. For details on each effect and on master EQ,
refer to PG p.217.
Working with the effect settings in
a combination
1
Select a combination.
Press the [COMBI] key to enter Combination mode,
and select the bank B combination 000: Stereo Piano
(☞p.5).
2
Access the P8: Edit-Insert FX, Routing page.
Press the [MENU] key to access the page jump
menu, and press the P8: Edit-Insert Effect button.
Then press the Routing tab.
“BUS Select” (IFX/Indiv. Out BUS Select) specifies
the destination to which the output of each timbre
will be sent. In this combination, timbre 1 is being
sent to IFX3, timbre 2 to DKit, and timbre 3 to IFX3.
The LCD screen shows the effect input for each tim-
bre. DKit means that the “BUS Select” setting speci-
fied for each key of the drum kit will apply. In this
drum kit, the sound is being sent to IFX1 and 2.
(☞PG p.170)
Here you can also see the effects that are being used
for IFX1–IFX4. Notice that the arrow extending from
IFX3 points into IFX4. The output from timbre 1 and
3 is being processed by these two effects connected
in series.
3
For details on the Insert FX page, the master
effects, and master EQ, refer to steps 3 and 4 of
“Checking the effect settings of a program.”
VALUE
PROGCOMBI
SAMPLINGSEQ
GLOBALS.PLAY
COMPAREMEDIA MENUEXIT 0
21
54
87
13
21
12
11 14
41
22

Korg TRITON Specifications

General

Type	Workstation
Oscillators	2 per voice
MIDI	In/Out/Thru
Effects	2 master effects, 1 insert effect
Keyboard	61 keys
Sequencer	16 tracks, 200, 000 notes
Waveform Memory	16MB
Floppy Disk Drive	3.5 inch 2DD/2HD
Optional	EXB-PCM expansion boards
Storage	Floppy disk
Audio Outputs	L/Mono, R, Individual 1-4
Polyphony	62 voices