16
Valve Force settings
Let’s take a look at the Valve Force settings in the combi-
nation B014: Old Wheelin’ CX3.
1
Select a combination.
Press the [COMBI] key to enter Combination mode,
and select the bank B combination 014: Old Wheelin’
CX3 (☞p.5).
2
Press the VALVE FORCE [ON/OFF] key to make it
light (Valve Force is now enabled).
3
Access the P9: Edit-Master FX, VALVE FORCE
page.
Press the [MENU] key to access the page jump
menu, and press the P8: Edit-Master Effect button.
Then press the VALVE FORCE tab.
In this combination, “Placement” is set to Insert
(User 3/4 BUS). This setting places Valve Force on
bus 3/4. You can create your sound by combining
various insert effects, or apply Valve Force to just a
specific timbre.
If “Placement” is set to Insert (Use 3/4 BUS), the
output from Valve Force is sent to the destination
specified by “BUS Sel.” (BUS Select) with the pan-
ning specified by “Pan CC#8”. If “BUS Sel.” (BUS
Select) is set to IFX1–IFX5, the output is sent to an
insert effect. “Send1” and “Send2” adjust the send
levels to the master effects.
“Input Trim,” “Ultra Boost,” “Tube Gain,” and
“Output Level” adjust the sound of the Valve Force
circuit. You can also set these parameters by turning
the front panel VALVE FORCE knobs.
Depending on the sound you are using, you may hear
noise if you turn the Valve Force knobs or edit Valve
Force parameters while sound is being produced.
4
Access the P8: Edit-Insert FX, Insert FX page.
Press the [MENU] key to access the page jump
menu, and press the P8: Edit-Insert Effect button.
Then press the Insert FX tab.
The post-IFX4 “BUS Select” is set to 3/4 (Tube).
After passing through insert effect 4, the signal will
be sent to Valve Force.
5
Access the P8: Edit-Insert FX, Routing page.
Press the Routing tab.
The organ sounds of timbres 1–3 are set to pass
through insert effect 4 (☞OG p.105).
Valve Force will apply to these timbres.
If you want to send the output of the timbre directly
to Valve Force, set the timbre output setting “BUS
Select” (IFX/Indiv. Out BUS Select) to 3/4 (Tube).
VA LVE FORCE
VOLUME VALUE
PROGCOMBI
SAMPLINGSEQ
GLOBALS.PLAY
COMPAREMEDIA
A
B
INPUT TRIM
ASSIGNABLE 1
LPF CUTOFF
ULTRA BOOST
ASSIGNABLE 2
RESONANCE/HPF
TUBE GAIN
ASSIGNABLE 3
EG-INTENSITY
OUTPUT LEVEL
ASSIGNABLE 4
EG-RELEASE
ON/OFFREALTIME CONTROLS
1
3
1
2
1
1
2
32
42
5
To Next Page
Loading...
