18
VA LVE FORCE
VOLUME VALUE
PROGCOMBI
SAMPLINGSEQ
GLOBALS.PLAY
COMPAREMEDIA
A
B
INPUT TRIM
ASSIGNABLE 1
LPF CUTOFF
ULTRA BOOST
ASSIGNABLE 2
RESONANCE/HPF
TUBE GAIN
ASSIGNABLE 3
EG-INTENSITY
OUTPUT LEVEL
ASSIGNABLE 4
EG-RELEASE
ON/OFFREALTIME CONTROLS
3
1
2
2
2
1
2
4
9
4
Input Setup
Tab
Sampling (recording a sample)
The TRITON Extreme can record mono or stereo, 48 kHz
16-bit samples. The Open Sampling System allows sam-
pling to be performed in Sampling, Program, Combina-
tion, and Sequencer modes. (Open Sampling System)
The various functions of each mode can be used while
sampling.
Here are some examples.
• Sample a vocal from a mic, and play it back using
“one-shot” playback.
• Send the input audio through an insert effect or
Valve Force and sample it
• In Program mode, resample a phrase played by the
arpeggiator.
Sampling a vocal from a mic, and playing it
as a “one-shot” sample
Here’s how you can use a mic connected to the AUDIO
INPUT 1 jack to sample a sound in mono.
1
Connect a mic to the AUDIO INPUT 1 jack located
on the rear panel.
Set the AUDIO INPUT [MIC/LINE] switch to the
MIC position, turn the [LEVEL] knob to MIN, con-
nect your mic, and then set the [LEVEL] knob to
approximately the center position.
2
Press the [SAMPLING] key.
You’re in Sampling mode. The Sampling P0: Record-
ing page is displayed. For this example, select the
Input/Setup page.
If this is not displayed, press the [EXIT] key and then
the Input Setup tab.
3
Press the page menu button.
The menu will appear. Press the scroll bar to display
“Auto Sampling Setup.”
4
Press “Auto Sampling Setup.”
A dialog box will appear. “Auto Sampling Setup”
automatically sets the parameters necessary for sam-
pling in each mode. When you sample, you may
find it convenient to use these settings as a guide-
line.
5
Choose “REC Audio Input.”
This will make the appropriate settings for sampling
an external audio source.
6
Specify the following settings for REC Audio
Input.
Set “Source Audio” to Analog. With this setting, the
analog audio source connected to the AUDIO
INPUT 1, 2 jacks will be sampled.
Set “Mono-1/Mono-2/Stereo” to Mono-1. With this
setting, the signal connected to the INPUT 1 jack will
be sent to the internal L channel and sampled in
mono.
Set “Save to” to RAM. The sampled data will be
written to sample memory (RAM).
Mic
13 11
12, 91
4
3
2
Scroll
bar
5
6
7
To Next Page
Loading...
Need help?
General
