Kostal ENECTOR - Page 63

Commissioning/configuration
1 12345678910111213141516
© 2022 KOSTAL Solar Electric GmbH63
If a KOSTAL Smart Energy Meter (KSEM) is installed in the house network and the wallbox
has been activated via an activation code in the KSEM, the wallbox must always be set up
as a slave. In this case, the KSEM is the master and controls the wallbox, e.g. for grid mon-
itoring (blackout protection), Solar Pure Mode (PV surplus charging) and Solar Plus Mode
(solar-optimised charging).
If the KOSTAL Smart Energy Meter is connected to the wallbox as an energy meter, it can
be used for grid monitoring (blackout protection).
NOTE
A list of approved energy meters and their purpose is available in the download area for
the product on our homepage at
www.kostal-solar-electric.com/released-energy-meters-wallbox
Configure the setting as desired.
Bank 2
Bank 1
12
45
3
678
ON
1245 36
78
ON
5
Wallbox Master
Wallbox Slave
ON
OFF
Bank 1
1245 367
8
ON
Configurable functions:
BankDIP switchFunction
15OFFThe wallbox (master) reads the data from the energy
meter (slave).
ONControl data is sent from the KOSTAL Smart Energy
Meter (master) to the wallbox (slave).
Application:
■ ENECTOR with KOSTAL Smart Energy Meter and convenience functions
■ ENECTOR with KOSTAL Smart Energy Meter for blackout protection (house connection
monitoring)