KRAL BEM 200 - Menu Description: Overview and TOTAL; Setup Functions and Variables List; TOTAL Menu Settings

12 Menu description
12.1 Setup functions and variables
12 Menu description
12.1 Setup functions and variables
Note The setup values can be protected by setting a password. See menu 6 - OTHER. When a password is
set, it must be kept in a safe place. After setting a password, the setup values can only be accessed
with a password.
No. Menu Submenu
1 TOTAL
o 1.1 UNIT
o 1.2 DECS
o 1.3 K-F
o 1.4 K-FD
2 RATE
o 2.1 UNIT
o 2.2 TIME
o 2.3 DECS
o 2.4 K-F
o 2.5 K-FD
o 2.6 MEAS
3 METER
o 3.1 SIGN
4 A-OUT
o 4.1 MODE
o 4.2 R.MIN
o 4.3 R.MAX
o 4.4 T.MIN
o 4.5 T.MAX
5 D-OUT
o 5.1 MODE
o 5.2 DECS
o 5.3 AMNT
6 OTHER
o 6.1 BEM
o 6.2 V-NO
o 6.3 S-NO
o 6.4 PIN
o 6.5 BL
Note The settings for total and flow rate are completely independent of each other. This allows different
measurement units to be used, e.g. cubic metres for total and litres for flow rate.
12.2 Menu 1 - TOTAL
No. Submenu Page (Information) Values Preset
1.1 UNIT Measurement unit for total and accumulated total.
Changing the measurement unit affects the val-
ues in the operator and setup mode, the K-factor
must be adjusted accordingly.
L; m
³
; kg; lb;
GAL; US-
GAL; bbl
L
1.2 DECS Display format of decimal values for total and ac-
cumulated total
0
0.1
0.02
0,003
0
1.3 K-F K-factor for Total 0.000010....
9999999
1
1.4 K-FD Display format of the decimal values of the K-
factor for Total
0
0.1
0.02
0,003
0.0004
0.00005
0.000006
0
Tab.7: Menu 1 - TOTAL
Operating instructions
OIE 24en-GB Edition 2022-01
17